| 
Microscale Products
Microscale Micro Sol [29.56 ml)
Setting solution for decals. Softens decals to conform to irregular surfaces for a "painted on" look. Brush Micro Set (Part 1 of this two step system) on the model where the decal is to be applied, then soak the decal in water and slide of backing paper into position on the model.Using a soft brush, gently apply Micro Sol onto the decal, being careful not to remove the decal during application. Do not touch the decal after applying Micro Sol, as the decal is now soft and can easily be distorted. Allow decal time to dry completely.On surfaces with many irregularities, additional applications may be necessary. Allow Micro Sol to dry between applications. If air bubbles become trapped under the decal prick with a needle and apply Micro Sol. Apply a final coat of Micro Set if required.
Microscale Micro Set [29.56 ml)
Setting solution for decals. Softens decals and improves adhesion. Brush Micro Set on the model were the decal is to be applied, then dip soak in water and slide off backing paper into position on the model. Carefully brush more micro set on top of the decal.Wait a few minutes for the decal to soften, then press the decal down with a piece of moist paper towel. Repeat as necessary, or use Micro Sol for more decal softening strength.To remove decals: Brush Micro Set on the decal to be removed. Keep applying until the decal loosens, then rub off or lift the edge of the decal and peel off with the tip of a hobby knife. Works only on decals that have not been over coated.
Microscale Liquid Decal Film [29.56 ml)
A solution to restore old decals or create your own. Liquid decal film restores old decals after one coat applied with a brush and allowed to dry. Also use to create your own custom decals. How? Take a piece of unprinted decal paper, coat with Decal Film, allow to dry, apply your design with ink, paint, dry transfers etc and then apply another coat of Decal Film. Allow to dry and use as normal.
Revell
Revell Color Stop
Revell Color Stop 30 ml
Fluid for masking areas requiring protection during painting. Revell Color Stop is a rubber-like mass which can be applied with a paintbrush to mask areas or lines. Once dry it is sprayed or painted over and then peeled off.
Decal paper:
Laser printer decalpaper so that youc an create your own decals.
(Inkjet Printer decal paper will follow in due course)
XtraDecal White Decal Paper
(Laser, Lettering, Paint and Photocopier)
A4 decal paper for you to print out your own decals. You can make your decals using rub-down lettering, painting, photocopier or laser printer.
Another key use of white decalpaper is to cut it into thin stripes to use for kill-rings on vehicle guns, window markings on sci-fi models and so on and so forth.
XtraDecal Clear Decal Paper (Laser, Lettering, Paint and Photocopier)
A4 decal paper for you to print out your own decals. You can make your decals using rub-down lettering, painting, photocopier or laser printer.
Experts-Choice Decal Paper
Regarded as amongst the best of DIY decal papers, Experts-Choice provide a single sheet pack that includes full instructions in writing and picture.
Expert Choice Decal Paper White for Laser Printers - 1 sheet
Sheet Size: 215mm (8 1/2") x 279mm (11").
Expert Choice Decal Paper Clear for Laser Printers - 1 sheet
Sheet Size: 215mm (8 1/2") x 279mm (11").
Expert Choice Decal Paper White for INK JET Printers - 1 sheet
Sheet Size: 215mm (8 1/2") x 279mm (11").
Important notice: Inkjet decal film is intended for use with inkjet printers only. Please choose laser decal film for photocopiers and laser printers. Laser film is located above the inkjet film.
Expert Choice Decal Paper Clear for INK JET Printers - 1 sheet
Sheet Size: 215mm (8 1/2") x 279mm (11").
Important notice: Inkjet decal film is intended for use with inkjet printers only. Please choose laser decal film for photocopiers and laser printers. Laser film is located above the inkjet film.
Tamiya Masking Tape 6mm
Supplied in a special dispenser with built in cutter.
18 meters length, 6mm width
Tamiya masking Tape 10mm
Supplied in a special dispenser with built in cutter.
        
|
